Navigation | Content



How to Fit Your Sticker

You are here: Homepage » How to Fit Your Sticker

Dear customer, this page will guide you and show you some tips and tricks how you can fit your stickers and help you to find all necessary information you need to succeed with an installation.

Very good preparation is the first step to succeed

  1. First step is to ensure that the surface is suitable and clean.
    IMPORTANT: ALL SILICONE, WAX, OIL OR POLISH MUST BE REMOVED BEFORE ATTEMPTING TO APPLY ANY STICKERS.
  2. Lay the Graphics face down exposing the white wax paper backing, peel this back to reveal the 'adhesive side' of the Graphics. Then lightly apply a mist of RAPID TAC from the 4oz bottle or better still from the LE PUMP SPRAY! - This should be applied to the Graphic and the surface to which it is being applied.
  3. Lightly position the Graphic in the desired position, checking alignment thoroughly.
  4. Using a squeegee (3M, Avery or MacTac) press and work the fluid from underneath the centre of the Graphic to the edge and out from the side using a herringbone pattern of squeeging overlapping strokes, so as not to leave a drop of fluid underneath the surface.
  5. After thoroughly squeeging over the complete surface of the premask, take a corner of the premask and roll it back on itself so as to reveal the Graphic.
  6. Finally over squeegee the Graphic with the felt side of the AVERY PRO FELT to leave the decal finger mark free and fully installed.

How to remove your unwanted sticker?

  • First, apply direct heat from a heat gun or hairdryer.
  • Second, use the QUICK RELEASE TOOL to remove the graphic without scratching.
  • Third, use RAPID REMOVE fluid to release adhesive from the surface and wipe with clean lint free cloth.